![]() ![]() Failure to do this will halt the install of these drivers. Again, FTP the 2 drivers to /tmp and make sure you Chmod them to 755. This can be applied via telnet quite easily. The smargo software package I’ve included does include a driver for the DM7020. Thanks to sonic1, ( I missed this part out.)Īgain, edit the CCcam.cfg to suit our new reader. ![]() You should now see the file you FTP’d in the list. Ftp the correct file to /tmp and then go to the Green Panel, then addons. It contains Nabilo packaged drivers for the DM7025 / 800 / 8000. Install the appropriate driver from this zip file. SERIAL READER : /dev/usb/tts/0 smartreader+ Ok, lastly lets edit the CCcam.cfg to suit our new reader. I think a reboot is required after enabling this. Go to the blue panel, and select Extras / Settings, then select Kernel Modules.Įnabled the ‘USB Cardreader FTDI’ option. Ok, so now your done with the Smargo setup tools. So run the Smartreader.exe and change the kernel settings to Dreambox and click Apply. Now we need to put the smargo in the correct mode to run directly in the Dreambox. If the firmware is v1.3 it will say so in the status bar at the bottom of the window and you can close this util, if not, click the update button and it will apply the update. Make sure the smargo is plugged into the PC with NO viewing card in it.įirstly, we need to check the Ambien Online smargo firmware version, so run the SmartreaderUpdate.exe OK, once the drivers are installed we’re ready to go. It will prompt for drivers for the USB device, then again for the serial device.Do a manual drivers install, pointing to the Drivers_Windows folder. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |